VCI 100 (Ean Golden Special Edition) + Traktor

I bought a VCI-100 Ean Golden Special Edition second hand and have tried a couple of times to get it to work with the latest Traktor and also Traktor 3 which I bought a few years ago - some of the features work - but not all of the buttons are mapped (e.g. the play buttons, for example, do nothing...). I'm completely new to any DIY mapping and was really hoping for a simple 'plug and play' experience - even if it means using an older version of Traktor. Could anyone give me a few words of advice for how to get the main features functioning properly?

I think the fact that's it's an Ean Golden special edition VCI-100 may also complicate things a bit too.

Thanks in advance for any advice!

If I were you I would check your Firmware, there have been many updates since the VCI-100 Ean Golden edition and you need to update your controllers firmware to utalize them. I am not sure if DJTT store still sells the firmware chip but you could check around the community.

http://www.djtechtools.com/2008/08/1...-100-firmware/

Awesome, thanks so much. And the firmware update is an actual physical chip, correct? (I have a Numark IDJ2 as well but its updates can be loaded on by USB).
Thanks again.

Also try using the djtt mapping, that's if it's running firmware version 1.4, the standard vci 100 mapping in traktor will give you weird results...

http://maps.djtechtools.com/mappings/1

Awesome - thanks so much. Ordered the firmware chip upgrade, now have it in hand, will try to get it fixed up over the next two weeks. Thanks again!