Lourma´s Setup

Time to show you my setup.

For me Digital DJ'ing is taking it to the next level and I think the selection and transitions is everything. For me it doe's not matter if you use vinyl, CDJ´s or computer. It's all about the music and using the equipment and tools YOU like!

Currently I run Traktor Scratch Pro with this:

Attachment 17596

And in a different light and placement of the gear:

Attachment 17597

I have the CDJ´s in HID, mapped to take care of transport on DECK A and B (Play/pause/pitch/hotcues/loops/flux mode)
The X1 is for DECK C and D (1210 timecode on D). The X1 also controls FX bank 1 (with delay, reverb and gater) and filters and key for all 4 decks.

The MF3D used a modified InstantGratification. Added new Traktor 2.6.1 fx tilting left/right and some other features.

Before I used a pair of EKS-XP5 but the resolution on the pitch was not ok for real beatmatching and no visual feedback. And a dual Denon 2000mk2 from 1991, still working, but I'm not using it anymore.
Attachment 17598

nice setup! just upgrade the mixer and you got yourself a badd-ass setup!
that case/laptop stand (in the last pic) look very intersting, can you show it a little more and explain about it??

Just bought a tool case. And added some bigger rubber feets to it.
Attachment 17804

Removed original hinge and replaced them with detachable hinges.
Attachment 17809

Added some mounting loops to the bottom and lid of the case that was in the right size for some metal pipes I found. Used some washers to adjust the size. I placed the loops as far to the back as possible on the bottom and in the center of the lid. (Make shure the case don't fall when you place your laptop on it!!!)

Attachment 17806 Attachment 17811 Attachment 17810 Attachment 17807

Used some IKEA screws that you use to connect 2 bookshelf's and a plastic washer to hold the equipment on a thin plywood. Then just put the plywood on the mounting angles on the sides of the case (as seen in previous pictures)
Attachment 17812 Attachment 17805 Attachment 17808

I used to have my Audio 8 DJ and the USB-hub mounted under the plywood and it also served as a support for the plywood in the center of the case.