My controller re-maps itself ?!?

My LOOP knobs (ZOMO MC-1000) re-assign themselves half way through a set!!!!

When it is SHIFTED, the LOOP knob scrubs through a track (I use it a lot). But, after mixing for an hour or so, it re-assigns itself to the phase meter!

This happens to BOTH LOOP knobs.

If I restart Trakor it is fixed. Any idea HOW this is happening? I'm not even aware of the phase meter being mapped to anything in any of my mappings. :confused:

weird.
check which midi notes these knobs send.
then order your controller mapping in traktor to list the midi notes and have a look, if these notes (also) trigger unwanted commands.

Ignore my foolishness. It's a push encoder, and it has second modifier attached to it for fine seek when it's been pushed... :blush:

Learn something new everyday.

:laugh::laugh: