DJ Tech DJM-101 LED mapping in Traktor pro 2

Hey guys, i'm new to this forum and I need help mapping my LEDS for my DJM-101 DJ Tech controller. I have everything working except for the Led's. Can u please help me?

Check out this thread.

Ty FrankieFilth. But that is not what im looking for. My problem is with the Master level LED's. on the DJM-101, not the CDJ-101.

Oh, my bad.. Had a long night. I'll see if I can come up with anything useful for ya!

I came across a thread somewhere that mentioned CC's 80 + 81 on Channel 1. Not sure which LEDs this is in reference to, might be the PFL buttons. I assume that all of your controls are on CH.1??

Will be a pain in the ass but, you may want to get your output commands set up, then go through every CC# (on CH.1) until you get the levels to show, trial and error.

I can't find the manual for this controller anywhere online... Seems that this controller is no longer supported by DJTech.
Do you have the manual that you can share with us?

@Rueben, I might have figured it out for you..

--PFL Buttons are CC33 + CC34
--PFL Meters are CC82 + CC83
--Master Meters are CC80 + CC81

I think everything is on Channel 1.

This is my interpretation of the Hex information in the manual found here.

@Stewe, I've just looked into Hex for the first time. I presume you might know a bit about it so, of course, point out anything I might have misunderstood. Also, it'd be great if you could share any general insight on the topic. I still don't understand where to get channel information from!

Thanks for the help! I got the LEDs working in Traktor with your tips.

However, the PFL buttons refuse to lighten up, no matter what I do. Should I give them some specific range or something?

Upload your controller .tsi and I'll have a look at it. Probably a quick & simple fix.

Ha, got it working!

Instead of giving the cc id of the PFL button, Ch01.CC.33 or Ch01.CC.34, I needed to give the note: Ch01.Note.A1 or Ch01.Note.A#1

Thanks anyway!