Traktor 2 Xone K2 mapping - Loop Size Selector Encoder

Hello guys! I'm trying to map the encoder for Loop Size Selector and I cant make it work... I've searched a lot on this forum (wich is great and read some nice people) and follow every suggestion but I can't make it work.

The configuration I have right now is the following:

Loop Size Selector
- Type of Controller: Encoder
- Interaction Mode: Relative
- Enc.-Mode: 3Fh/41h
- Rotary Sens.: 10%
- Rotary Acel.: 0%
Inverted

I read this configuration in this forum but didn't work also... either with 7Fh/01h..

I have Traktor Pro 2.6.3 and an Allen and Heath Xone K2

Hi Markos and welcome to forums,

Normally it should be set to encoder as you already saw in the forum - try switch this in to Fader type. Rotary sensitivity should be around 100%

I don't have a clue as I don't have a K2 but I remember form my previous A&H controllers that some encoders are actually buttons (left and right messages). May be you should check that? I really don't know I may be not of much help here ^^

I had a K2 for very short time, all encoders have a CC type of message unlike the Xone 1D controllers where the Note message was implemented.