Printable View
Hey Everyone,
I'm thinking of upgrading to DIY Arcade Mode (when it's available), has anyone removed an old overlay before and then replaced it with the Arcade Mode overlay? If so, was it a pain in the ass to remove the overlay and all the adhesive?
Thanks,
Mark
I believe you can just throw the new one over the old one, but its up to you. I have not removed an overlay, so I can comment on that matter.
You are going to have to take off your existing overlay regardless if you want to do the arcade mod. I don't think the machine shop would be able to cut your faceplate unless the overlay was removed. I have removed a few overlays before. It is a hassle, but shouldn't take more than 5 minutes or so.
Dero2,
Yeah, I'm going to remove Traktor Pro VCI-100SE overlay and replace it with an Arcade Mode overlay. The overlay has been on for sometime, but sounds like from your experience it shouldn't be too difficult.
Many Thanks,
Mark