I couldn't figure it out. I think I'm going to delete the whole thing and reprogram it all from scratch (oh yay, excitement) and then program the tks one step at a time again.
Not looking forward to it at all.
Printable View
I couldn't figure it out. I think I'm going to delete the whole thing and reprogram it all from scratch (oh yay, excitement) and then program the tks one step at a time again.
Not looking forward to it at all.
Maybe first draw it on a piece of paper, what function you want and where. And than strike through every step you just have entered in Traktor?
(That's what I did with my BCR)
And maybe leave the Bomes MIDItranslator out of the story, as that that will add to extra error sensitivity during the input phase.
Well, without Bomes I can do it with the footswitch. It just requires me having a padkontrol, or something that accepts the midi notes from a footswitch. Bomes would allow me to do it without that, but, well, oh well
Well, just look how far you can come with just traktor.
And after that if you still need to add your footswitch, just add it for that input only?
(Cause I have seen a lot of double mappings in your Bomes and tks file, or is that one of the key requirements?)
that's pretty much the point I've come to. I need the footswitch to change MIDI pages so I can control four decks. I'm starting to get the hang of it. Now I need to remap my PadKontrols a little, and figure it out from there.
I don't know about the double maps. Any chance you can get on MSN and we can discuss?