-
PILX - I believe holding down the first of the small black buttons on the left while powering up a 1.2 vci100 will set the unit to channel 2. Doing the same thing with an SE/1.3 will NOT set it to channel 2, but instead will temporarily revert it to 1.2 firmware. Confusing enough? Basically, if you want to use two 1.3 vci's on one computer, I think you've gotta use a method like JesC is describing.
-
Has anyone got this method working on Tpro, I still get everything on channel 1
-
You trying this with 1.3? A translator will do the trick. 1.2 on one or both? Then the first black button on power up will change the unit to channel 2.
