Traktor mapping tips, tricks and questions.

Quote:

---

Originally Posted by Stewe

I've made two buttons that act as you have described but adding third button in this loop requires a shit load of modifiers and maybe it's impossible to achieve... Will give a few more attempts to make this work but it doesn't promise much of success really.

---

Well I appreciate your help either way thanks.

No problem, I like this idea too and will look into it. I'll share tsi here if I get any results.

here r tutorials but idk if its what you want it to do but it might help
http://www.djtechtools.com/2011/02/0...treet-fighter/
http://www.djtechtools.com/2011/02/0...ced-modifiers/

Quote:

---

Originally Posted by midinoob

here r tutorials but idk if its what you want it to do but it might help
http://www.djtechtools.com/2011/02/0...treet-fighter/
http://www.djtechtools.com/2011/02/0...ced-modifiers/

---

I think he is looking for something different than connecting modifier conditions in a row and in only one direction.

i tried it but i think it can't be done with just one modifier, you'll need two or just a fourth button to turn on the effect much easier in my opinion.

At a point i thought i succeeded but unfortunately the effect didn't turned off if you just pressed 1 or two buttons

good luck!

Quote:

---

Originally Posted by DJDoubleYou

i tried it but i think it can't be done with just one modifier

---

Agreed! At least three modifiers.

Quote:

---

you'll need two or just a fourth button to turn on the effect much easier in my opinion.

---

This. One hundred times easier :lol:

*Edit*

Here is base:

Quote:

---

Originally Posted by Stewe

Agreed! At least three modifiers.



This. One hundred times easier :lol:

*Edit*

Here is base:

---

Thanks for the help guys, i did consider adding a fourth button to turn on effect, and then using the current 3 just to set values but in my workflow it doesent quite feel right.
It just means i can only roll up through the values or down not both. I'll probably just live with that, thanks again.

http://www.youtube.com/watch?v=5kQzeNeWPu0

Here are all the parameters I've used in vid if you are interested to map it for your controllers:

http://i.imgur.com/m6f8t.jpg

Quote:

---

Originally Posted by Stewe

http://www.youtube.com/watch?v=5kQzeNeWPu0

Here are all the parameters I've used in vid if you are interested to map it for your controllers:

http://i.imgur.com/m6f8t.jpg

---

I like, Shall add to the UltimateFx thread, I will make a new section known as... Miscellaneous Fun Stuff! Im going to this out to a keyboard... :)

Quote:

---

Originally Posted by 0Notice

I like, Shall add to the UltimateFx thread, I will make a new section known as... Miscellaneous Fun Stuff! Im going to this out to a keyboard... :)

---

Assign all commands for target device so you can add focus selector to use this on all decks.