Vci-300 tsi

Quote:

---

Originally Posted by BradCee

the intergration between software and hardware on the s4 system is HID as opposed to MIDI, works smoother and faster with all the outputs.

---

Ok.. good to know.

Quote:

---

Originally Posted by BradCee

did some digging and it turns out that itch probably uses HID to drive the LEDs on the 300 as well...

---

Where did you find this information? Sure about it?

Quote:

---

Originally Posted by BradCee

annoyingly HID support is a difficult thing to run on a 'generic level' (different devices use different signal packets) so chances are if software and hardware moves on to use HID instead of MIDI things could get a bit more pricey.

---

Yep.. MIDI is pretty simple and straight-forward..

Quote:

---

Originally Posted by BradCee

good news about separate audio and MIDI threads in a future update. i'd guess that's more than likely already in the new software (running alongside the HID side of things), and ready to go for a future TPro update, along with those cool little sampler decks.

---

Traktor Scratch Pro users should get an update to TPro S4 version.. looking forward to it :)

Quote:

---

Originally Posted by pasik

Where did you find this information? Sure about it?

---

asked an expert, remember i used the qualifier 'probably'

pasik ---- any progress brother?

^^Ditto^^

Hello guys. Sorry, I've been busy lately, but I'll try to get the first version out soon. I'll give you an update here when it's out!

http://www.djtechtools.com/forum/showthread.php?t=17616

http://www.djtechtools.com/forum/sho...d.php?p=156991

well i have been getting into these threads on Traktor Pro LE 1.2.7 is what im currently using with windows 7 on my laptop and when it comes to the beginning of trying to use hazes324s midi mapping for the vci300 i run into a problem into the control manager in the device setup which im a noob trying to add the preset so i can actually use my setup would any1 have some advice on this troubleshoot prob im having so i can move forward and get this going?steps would be very helpful....thanks

Hi guys,

I wanted to make this post long time ago...my apologies for the delay.
After reading many posts and using a combination of mapping settings from various users of this forum (I thank them all!) I came up with the attached VCI-300 TSI mapping. It does not include any effects but it enables you to successfully use an external sound-card and traktor with the controller. The experience is almost the same as if you were using Serato ITCH but now you can have a far better sound since you can use an external sound-card as well as more mixing possibilities with the Traktor software.

I hope it helps!

Cheers,
nIkNaK
soundcloud.com/groove-service