Printable View
Hi
I've been trying to map an LED out to the loop command I set but I can't figure out how to do that.
I've mapped the MF3D
Ch03 Note E2 - Type of controller: Button - Intercation Mode: Direct - Assignment: Deck A - Set to Value 1
How do I make an LED out active when the "loop" command is set on? I know that I the value for the On command should be 76 due to the color green.
Any input appreciated.
MOE
Add out > 'is in Active Loop' Using this command?
Out > Loop Active On ? Or not?
Min 77 for light green and 76 for bright when on. Min 0, Max 0. ???
Nope. It's 'is in Active Loop' under Deck common menu > list bottom.
Should be 66 for green if 3D now has same LED velocity as Spectra.
No on the 3D its different according to the documentation. Oh now I found it. I'm not working it for some reason.Attachment 18568Quote:
Originally Posted by Stewe
You have correct modifier condition there?
Yes. I cant imagine it being wrong. I even tried a different button that has no button and mapped all functions there but also didn't work. :confused:
I can't say for sure about 3D though... Try setting range to 1-1 and combine blend.
Not all controllers are treating traktor output the same.
Could it be that I messed up? As you know the MF3D has 4 Banks which I enabled them including the RemixDeckFirmware.
I used the "Modifier 1" basically on three pages so far. Technically its the same shift button, or not?
Bank1 & Bank 4 should control Deck A & B. Simple mapping such as Play, Cue, Sync, Loops & Hot Cues. Bank 2 should be EQ. Bank 3 FXs.
So far I've mapped all except Bank 3. I havent figured out the right settings for LEDs on Loops & Hot Cues. Everything else works like a charm.
It is a same modifier but it's not the same shift because each bank is sending unique midi note. Meaning, if you press that shift in any of banks the same modifier will be activated unless you add multiple mapping devices and assign each bank for individual modifier.Quote:
Originally Posted by moey2k2001
Would you suggest to leave it? Or use a unique one on each bank? But since I am using the in/out ports to the specific MF3D, is it possible that adding more equipment could collide in the mappings?
I wanted to send LED feedback but I cant get it to work. I got LED feedback that are always on. How about Hot Cues, how to I send unique feedback depending on what's saved in a song on each load? Ex. Loops, Load, Cues identical colours.
You'll be fine as long as each device is selected to MF.Quote:
Originally Posted by moey2k2001
Only way to map cue colors is by assigning modifier conditions. For example if you want to lite green when your loop is stored go ahead and try this:Quote:
I wanted to send LED feedback but I cant get it to work. I got LED feedback that are always on. How about Hot Cues, how to I send unique feedback depending on what's saved in a song on each load? Ex. Loops, Load, Cues identical colours.
Add Out > Track Deck > Cue > Hotcue 1 Type
click modifier condition slot > select hotcue 1 type > assign to deck
click slot value > assign LOOP
use MIDI range to choose a color
Done.
Thnx. :thumbup: I decided to keep them on the whole time instead. It gets too confusing when working with all decks and too many colors. I left all loops lit green and cue points 2 different ones for each deck so I can recognize the difference. :rolleyes:
Anyway to make the LEDs flash to the loop?Quote:
Originally Posted by Stewe
Use MIDI range to choose a color. Download the MF3D manual. Midi ranges are written inside.Quote:
Originally Posted by DjYanaki