Printable View
First post
Hello All :thumbup:
I have a denon mcx8000, the xfader is dead...easy to replace but a thought popped into my head about switching it for buttons
Taking it out there is three wires, so in my limited electrically minded knowledge thought that shorting those two wires would just mute the channel left or right dependant on what wire was put to the ground??
unsure if that reads ok
this is the denon fader
https://www.planetdj.com/media/catal...c4k-b173-1.jpg
Well ok to the 70 viewers thanks for your time
If you wish to do the same
ADC is what you or I would call a ground
GND is left
ACC is right
or vice versa
will post the mod when my switches arrive x
Yoo that doesn't sound right, VCC should be your + voltage (usually 3.3v or 5v) GND ground and ACC your signal. So connect GND to ACC for the one end and VCC to AVV for the other. Throw some resistors in there so you don't accidentally shortcircuit when pressing both buttons at the same time.
Thank you for the reply and yes...you are correct
I think for now I'm just gonna go with the one button :o
Would a diode be a better option over a resistor? for later mods