Does any one know whether the Allen & Heath Xone:62 mixer is compatible with the Chroma caps on the DJTT store?
Tried the compatibility table at the bottom, and no mention of my mixer.
Printable View
Does any one know whether the Allen & Heath Xone:62 mixer is compatible with the Chroma caps on the DJTT store?
Tried the compatibility table at the bottom, and no mention of my mixer.
well it's not compatible then.Quote:
Originally Posted by Gribble
Cheers for the clear response . .
Some mixers listed had - NO - NO in the table (https://store.djtechtools.com/chroma...=Chroma%2BCaps)
That's why I asked as DJTT can't name every mixer / controller on the planet and needed some clarity from possible Allen & Heath owners . .
That's not necessarily true as some listed aren't compatible. Op, If I could find one locally i would try for you but they don't sell them in stores round my areaQuote:
Originally Posted by MYE
I know for a fact they don't fit on a k2, don't know if it helps, but its Allen and Heath so might be similar.
I think someone said they go on but the white line doesn't face the correct way - but not 100% on that...
Might've been K2 they were on about..
i think you can fit the fader caps (did that on my 92) but they do not sit properly, they go down too far and scratch on the surface. the knobs fit but the white lines are turned 90° to the left. so all in all not how you want it to be.
talking about the 92 here, but i dont expect the 62 to be different in that case.
Same goes with the DB2/4. They 'fit' on the knobs, but the markings are 90 degrees off. I imagine it's the same for all their mixers
Doesn't fit the xone 22 as well. DJTT you know what you have to do!^^
A&H pots are strange and the flat part is 90* off from like every other pot so no they will not fit.