Encoders and pots are very different.
It has the same style as the S4 pot, but different design.
DjLiquitATL: If you can get me measurements of everything on the encoder I can look for it later. Dimensions of base, length of shaft, etc.
Printable View
Encoders and pots are very different.
It has the same style as the S4 pot, but different design.
DjLiquitATL: If you can get me measurements of everything on the encoder I can look for it later. Dimensions of base, length of shaft, etc.
Yes, the function is different but the housing is almost identical. There don't seem to be any matching encoders on the Alps website though.
I know how to solder and use a multi-meter...that's about as technical as I get...if this was a 1200 or analog mixer i'd be all over it...I've changed multiple bad pots on DJ mixers BUT never a encoder and never something that I have this much trouble locating the part for
i'll try to post specs in the morning...BUT i'm pretty sure its a 15mm shaft
Look at the spec sheet I linked on the previous page; it shows the proper way to measure the length of the shaft.
Yea. The datasheet will show you how to measure everything properly.
You just need a pair of calipers.
I really don't understand why NI is so anal about not selling parts. They already have a sticker over a screw for tamper evidence..
Because it costs <$200 to build an S4 from scratch
I give up on the search for the encoder. Going to send to NI for a new/refurb unit for $140.00 :cursing:
Ack. If you send me the dimensions I"ll hunt it down for you!
Or you can mail it to me if you don't have calipers.
Warranty voidage = you pay for repair
They'll still work on it.