xone 2d led mapping question

[johnak47]

Hey guys im tryin too set the leds on the 2d too be 4 modifiers

so modifier 1 would be 1 light on

modifier 2 2 lights on

modifier 3 3 lights on
etc etc


is this possible or do the default on off leds built into the xone 2d overide traktor im finding that i need too press the button 3 times too switch the light off after the modifer change


any pointers greatly appreciated as were having a rave in the woods at the weekend and the visual indicators would make it a lot easier so i know what modifier im working with

[Yul]

- set up the light pipes from the unit as stated in the beginning of the manual (rtfm)
- the rest depends on what you plan to do: is it a single modifier with different values (if you're going to press only one button at the time that would be the best choice) or is it several modifiers that may be pushed together eventually?

[dirkd]

Could you detail in some way how you have gotten the lights to work at all?

I've been trying for a few days to get my Xone2d's LEDS to respond to MIDI out messages in Traktor and I have yet to get even one of the LEDS to light up.

I've been reading various conflicting reports that the leds are either assigned to MIDI notes outside of Traktor's assignable range, that they don't work at all or that you need to send the message twice to get the LED to respond.

[Yul]

I used to have a 2d, the light pipes do work fine with Traktor without any external software.