Is there anyway of setting up effects pre sets in traktor pro

**Dave Mac** · 08-22-2010, 12:10 PM

Basically I'd like to be able to set the effects with certain parameters that it snaps to when selected. At the moment I can only work out how to either reset each effect upon selecting, or they just carry over from how it was set from the previous effect. I would like to set it so that each effect defaults to something i've selected that i know well, then use my knobs on my vci100 to tweak them if i so choose to. Any ideas people.

**Eliot Han** · 08-22-2010, 03:52 PM

... i would like to know as well, always setting up the advanced controls before starting is quite tedious esp if you are trying to run 6 fx's.

**photojojo** · 08-22-2010, 04:09 PM

The little camera icon next to the FX sections will take a snapshot of the settings and make them the default. You can also set the amount the FX are loaded to in the mappings.

**Dave Mac** · 08-23-2010, 02:46 AM

Originally Posted by photojojo

The little camera icon next to the FX sections will take a snapshot of the settings and make them the default. You can also set the amount the FX are loaded to in the mappings.

Thanks jojo, not for the first time your my saviour!

I'm going to download your mix to listen to down the gym.