Kontrol S4 issue with Live PA

[Helldrift]

Hi guys.

Having an issue where if I try to do scratching on the jogwheels, the speakers have some distortion or noise. I tried jogwheeling on a channel that wasn't on air, even with filter at 100%, it seemed to 'lag' or slow down the playing channels audio + continue to distort. I'm running a laptop to the S4, as well as a X1. I'm using the TRS outputs to a pair of RCF 310A's with XLR cables.

Any assistance would be great as my scratching last night was embarassing! :P

Btw I'm running the current Traktor Pro S4, was hoping to rectify this problem before upgrading to T2.

[photojojo]

What's your latency set at?

[Helldrift]

Well my S4 currently isn't connected but just opening it (with no audio routed) it says 10.2 (processing) 10.2 (output) = 20.4. Hope that helps?

[miha101]

.....way too much, change the buffer size settings, until you get under 10....but i'm not sure it will solve your problem...

[manchild]

you might be clipping and the master limiter is turned on.....worth a look

[Helldrift]

Alright...so what should I do apart from the buffer?

My levels were fine all night, occasionally too much bass led to entering the red zone in the channel but never in the over master output.

[photojojo]

there's a software volume and hardware volume so it's a little tricky to get dialed in and my not show up as red on the controller. I run my software volume around -5 or so most of the time. Is auto gain on? What about the limiter? Some have attributed funky sound to the limiter.