Can't map SHIFT button on VCI-380

[Poulet Blanc]

Hi everyone, it's been a while!

Recently I bought a VCI-380. At the moment I'm mapping it in Traktor, but it really gives me a headache...
I have been mapping my SHIFT key on the left deck (A) as Modifier #2 (Modifier #1 being the jog scroll/load A/B button in the middle of the unit).
Somehow I can't seem to get it working... The weird thing is: shift works perfectly when I map the shift button (modifier 2) as a direct knob instead of a hold knob.. However this is not what I want it to be...
Perhaps I'm just missing something.
I included some screenshots:
Schermafbeelding 2015-06-18 om 21.36.44.jpgSchermafbeelding 2015-06-18 om 21.36.33.jpgSchermafbeelding 2015-06-18 om 21.36.24.jpg

I hope someone can help me!

Grtz M

[Poulet Blanc]

Wow... Those sceenshots are really small..

Re-upload:

[Stewe]

Try to midi learn the same hotcue while the Shift button is pressed. Since that is a Serato controller Vestax might hard coded the shift button to switch the midi channel or set another pair of notes (Pioneer does this too - it's nice option when you map a software which isn't supported by modifiers).

[Poulet Blanc]

Try to midi learn the same hotcue while the Shift button is pressed. Since that is a Serato controller Vestax might hard coded the shift button to switch the midi channel or set another pair of notes (Pioneer does this too - it's nice option when you map a software which isn't supported by modifiers).

This was the solution! Thanks a lot mate.