MIDI Fighter Twister LED Ring update

[Monaco Flow]

Hi guys,

I am working on a FX mapping in Traktor for my MIDI Fighter Twister and I just cant figure out whats the problem with updating my LED Ring. I have attached a very simple TSI, maybe there is just something I dont know about mapping LEDs yet.

The idea is that the Dry/Wet of the FX1 bank is mapped to the LED rings of the upper row of the controller. The first knob in the third row controls the Dry/Wet. Additionally, when pushing one of the upper row buttons, the Dry/Wet resets to 0.

This works in 95 percent of the cases and the LED rings of the upper row turn black when I push one of the buttons, but sometimes the LED of the button I push (have not figured out when and why but it seems to have to do with the speed I push it) stays at the level that the Dry/Wet was before resetting it to 0. Once the Dry/Wet is being altered, the LED resets to the correct value but it indicates a wrong value until you do.

I have been playing with this for hours over hours now and I cant figure it out, any help appreciated.

Cheers Mike

[Stewe]

I tried with my Twister but I couldn't reproduce it. Added the Send Monitor State command to your TSI - see if it helps.
Here you go: Twister LED Update.zip

[Monaco Flow]

Hey Stewe, thanks very much for trying to help.
I have the same problem even with send monitor state. Maybe it is a hardware problem after all.

[Stewe]

I don't see anybody downloaded my file jet (0 views)
Did you try the mapping I provided or did you tried mapping Monitor State on your own?

[Monaco Flow]

I "re-engineered" the send monitor state with Store FX preset from the Macro FX mapping before.

But I should have taken a look at yours first maybe I made a mistake. I will take a look at it on the weekend mate. Thank you again.

Cheers and have a great week

Mike