Upgrade Issue !

[Labobinne]

Hi everybody !

I have tried to upgrade my VCI 100 1.1.

AND... I have the 15024 Error number : Boot failed.


- 1
So, First when I make the workflow I put the VCI in boot mode. BUT, There are no lights on.

Is this step good or Should it be flush?

- 2
After, I launch my upgrade with a usb/serial cable on an opened Com (COM 5 for example).

And I have the error (see above).

So I have tried to unplugg the firmware from the VCI, and to unplugg the firmware kit and to lauch the soft with just the usb/serial cable :

And I have the same error !


So I don't know where does come from this issue...


Could you try with your cable alone to compare results?

I am lost ...


Thanks !

[midifidler]

Follow the video closely and read the FAQ very carefully.

Many people have issues with USB serial so it may pay to find a computer with a built in serial port and use that.

[Labobinne]

Thanks for your responsiveness !

I did exactly the procedure that ean says in the video but a pop up says that a vci with no lights is not good...

So what is the good thing : No lights or flush?

Thanks for all

[Labobinne]

OK problem solved :

It works fine with my usb/serial.

The issue was coming from the alimentation. In fact, when I tried with my Macbook usb port (who knows my vci) it was not ok.
Then I tried with the PC usb port and it was ok.

2 solutions :

The voltage is higher?

OR

The PC has never instaled the vci so the voltage was not the same ???

Bye

[midifidler]

Probably a flakey driver...
Glad you got it sorted