VCI-100 LED Question.

[Endy101]

Hey guys,

Sorry, I've just bought a VCI so I'm probably gonna have a few questions over the next couple of days. The community here has always been very good to me so I'll hope you'll bare with me!

So, todays problem: Without going too much into it, I've mapped 'SET CUE' button below the jog wheel as a 'toggle' button. However, the LED will only turn green while the button is pressed.. ie the LED is acting like a 'hold' button when I want it to act like a 'toggle' button.

Is there anyway of changing this as I can't seem to find away and it's really gonna screw up the mapping I've been planning for this machine.

Thanks guys, any help as always is greatly appreciated.

[photojojo]

Have you seen this?

http://www.djtechtools.com/2010/05/3...ds-in-traktor/