Problem getting traktor to work with my spin

[djlooms]

title says it all. I have my spin plugged in i open traktor load a .tsi file and nothing happens

[kenvilo]

I have the same problem. Let me explain in more details:

I'm using Windows XP, Traktor Pro 1.2.5.
With the help of ASIO4ALL v.2 I managed to set Output Routing to SPIN's soundcard.

The problem comes when I try to use it as a controller. In Controller Manager I imported a couple of .tsi's from the forum, also tried Typhoon's .tsi from Vestax website. Nothing happens. No any response from faders/knobs movement, as if the SPIN was not connected 8-(
Would anybody be so kind to tell me (and djlooms) if I missed something. May be there is some mysterious "apply" button that I am missing to press?
Thank you in advance.

[photojojo]

Have you selected the Spin in the in/out ports in controller manager?

[kenvilo]

Thanks for the reply
When I select one of the spin mappings by dmb from the forum, in the window in/out ports it says "n/a:SPIN DJ-Controller". When I try to select the ports, I only have a choice of "All" or "None".
When I select Typhoon mapping only "All" or "None" are available.
Any suggestions?

[Glen]

click all. If you do then it will accept any midi signal that comes its way. then mabey it will detect the spin. Sometimes this works with my vci

[joelsmith1978]

I am having the same problem. I started mapping it out but the scratching isn't right. I set the scratch function up on an APC40 but can't get this to work. I had it working in Windows but not on my MAC. Usually it's the opposite...

[photojojo]

Did you use the big import button on the bottom left of the preferenc pain? You can also use the setup wizard.

[joelsmith1978]

Both of those didn't work but I found the problem. I have imported many tsi's before with no problem. What I found out was after updating to 1.2.4, everything works fine. I had 1.2.4 on my PC and 1.2.1 on the MAC, oops.