Thanks, now it works! Pin 22 of TLC5928 is the serial data output.
For those of you interested in getting into the bootloader mode faster, you can solder two microswitches on the board. This method was mentioned in another sticky.
I used two direct mount switches from radio shack. These are small enough so you can get your fingers on both switches when the MF is assembled.Originally Posted by Fatlimey
Last edited by Jason Cerna; 03-24-2011 at 04:50 PM.
Maybe I'll go visit the shack tomorrow. I want to do the LED mod anyway.
like the bag says. 5mm tact switch. no wires needed. you solder the terminals directly onto the board.
thank you sooo much
*ragarding my other post*
i bought these buttons and had a friend solder it and BAM! im back to beat mashing
thanks again for your help
Much obliged!
SAVED MY MIDIFIGHTER! Thanks guys!
when i try getting into bootloader it shows the LED display but in the MFUpdate application it says failed to recognize midifighter in bootloading mode....??? what am i doing wrong?
Last edited by photojojo; 06-23-2011 at 07:50 AM.
|
Bookmarks