Linking Midi Fighters Query

[jds1]

It it possible to link two midi fighters,
whereby the first can be used for mixer/effect/cueing/looping etc,
and the other is used as state/bank/page select etc?
It's basically using one as the 'editor' and the other as 'navigation'.

I thought this could be useful so you could remove shift/modifiers completely from a midi fighter so more parameters can be tweaked on it.

[zestoi]

It it possible to link two midi fighters,
whereby the first can be used for mixer/effect/cueing/looping etc,
and the other is used as state/bank/page select etc?
It's basically using one as the 'editor' and the other as 'navigation'.

I thought this could be useful so you could remove shift/modifiers completely from a midi fighter so more parameters can be tweaked on it.

not without middleware software like my midimasher. you can only link one tsi to one input and one output port and modifiers aren't shared between them, so depends how much u need them to interact. you also can't change a "4banks mode" midi fighter's bank via midi afaik, but u can via midi masher if you let it emulate the 4banks mode from a normal mode midi fighter, which is how i always use mine.

i have my midi fighter set in normal mode and use midimasher to create multiple layers on it, which are changed from a control on my launchpad (i.e: u could use your other midi fighter). you could also change the current bank of the emulated 4banks mode midi fighter from a different controller then too - since the 4banks is emulated within midimasher and not within the midi fighter itself.

if u don't need any actual interaction between the 2 midi fighters then u can just create a custom tsi for each one and map whatever u need on each ofc.