Another set up problem....

[carline1889]

Hi,

First let me apologise as this may have (no doubt) already been asked but i have been unable to find an answer!
I have just received my new Midi-Fighter classic but I'm having issues with mapping the IG mapping. Can anyone help?
I have followed a number of instructions on this forum but still have the same issue. Hopefully it will be something as easy as a 'tick in a box' but I've been at this all day and still having the same problem.
Ive imported the .tsi ticking the correct boxes
Ive have made sure i have the latest firmware
Ive made sure the Midifighter is in port and out port for all A-D decks
The hardware is on 4 banks mode
The effects are mapped ok
All i get is the CTRL option in the middle at the top of Traktor showing that there is a signal but none of the effects are triggered.

If anyone can help me with this problem it would be greatly appreciated.

Matt

[carline1889]

BUMP!
I take it not many people have come across this issue? Can any MODs help?

[Peachy]

BUMP! I have same problem.

[carline1889]

After speaking with Zach at djtt i found the answer....
The Midi Fighter was on the wrong channel, make sure its on channel 3. See link...

http://forum.djtechtools.com/showthread.php?t=9961

[Lilja]

Hi,

First let me apologise as this may have (no doubt) already been asked but i have been unable to find an answer!
I have just received my new Midi-Fighter classic but I'm having issues with mapping the IG mapping. Can anyone help?
I have followed a number of instructions on this forum but still have the same issue. Hopefully it will be something as easy as a 'tick in a box' but I've been at this all day and still having the same problem.
Ive imported the .tsi ticking the correct boxes
Ive have made sure i have the latest firmware
Ive made sure the Midifighter is in port and out port for all A-D decks
The hardware is on 4 banks mode
The effects are mapped ok
All i get is the CTRL option in the middle at the top of Traktor showing that there is a signal but none of the effects are triggered.

If anyone can help me with this problem it would be greatly appreciated.

Matt

When importing, make sure you are importing the mapping TWICE: First time import the effect settings and controller mappings, then when doing the second import, just check the effect settings box. If it doesn't work: i'd suggest contacting DJTT support.

Also: when you mentioned that the ctrl light is flashing, then you shouldn't worry about having an hardware issue with your MF. Remember: If the ctrl light is flashing, it means it is receiving MIDI from a device connected to Traktor!

Hope it helps!

[carline1889]

After logging a fault, this has been solved. The problem i was getting was solved by setting the MF to Midi channel 3
http://forum.djtechtools.com/showthread.php?t=9961