TRAKTOR mapping help on how to Change what deck is playing current song?

[Stewe]

Now why is my MIDI jacked up?

It definitely got to do somethig with the way you controller is sending massages. It seems like it sends only one massage when you hit the button without second massage on releasing. Check your manual and see how to configure button type.

[Stewe]

Sure does skip a bit when I do it though. Seemed less jerky when I was having both play....

You can add command which brings your deck A volume fader down to zero to overcome delay between duplicating and unloading.

[djmichaelwenz]

I tried mapping it to another controller and I had the same results on another computer with a different controller I use an MPK Mini... I tried the volume change message and it did work but it was jerky as well. Also this is an effort to use two turntables with 4 decks and external mixer mode. I will keep checking stuff out and try to see what is giving me problems...

[Stewe]

I tried the volume change message and it did work but it was jerky as well.

Haha! Until Traktor can offer some more advanced features we must satisfy with what we got.

[djmichaelwenz]

So after almost a year I am back on this, I have much more experience mapping in Traktor/ Modifiers ETC. I have gotten this to work with my Allen and Heath K2 using a single command to duplicate and unload but there is a bit of a pop when I do so sometimes. Also I am looking for a way to have exactly the same Eq and Gain settings when duplicating decks from A to C. I am on the latest version of Traktor 2.6.4.

Anyone out there have a workaround for this? I am looking to use an Audio 8 + K2 with a 2 channel mixer playing 4 decks. I basically want to have a track that I am mixing out of either play a loop or just finish playing and open up decks A and B for Turntable control while keeping the layering going. I thought about using the loop recorder but seems a bit clunky... Thoughts?

[djmichaelwenz]

So I found that when swapping decks and having the unload set to invert and kick in when I release the button as long as I go slower with the button press there is less likely a pop when swapping. The eq and gain settings can be the same as long as I set the gain to "0" and use the auto gain. This seems not so bad right now.... Gonna test properly later today.