Any interest in a Numark Total Control mapping?

[fffiiissshhh]

No problem. Have fun. Warning - you may run into an issue with the filters (when turned all the way down they might turn themselves off.) I have since fixed this and if it's problematic i can upload the fixed version

The only other majorly annoying thing is that the loop shift button is a toggle and not a hold, and that if you forget to turn it off you cant do a lot else (it kills a few other functions.) I ran into trouble with the LED for that shift on hold mode and so decided to make it a toggle, but it's a little impractical. This may be something where function should be prioritized over form instead of the other way around =)

[fffiiissshhh]

Fixed:
- Filters turning off when all the way low or high
- Shift button that turns the loop length buttons into loop shift forward/back buttons is now a hold, not a toggle - so you dont have to remember to turn it off

Changed:
- FX banks now control 3 and 4 INSTEAD OF 1 and 2 (just a personal preference as my mpd26 maps to fx banks 1 and 2)

Added:
- Set Cue button (middle button below each deck) now acts as Loop Roll (beatmasher) enabler
To use: Hold set cue button and it will automatically enter a 4 beat loop roll. To halve the length once (2/4), press Pitch Bend -. To halve again (1/4), press Pitch Bend +. To halve again (1/8 or 2/16) press Loop In. To halve again (1/16) press Loop Out. If you want to halve it one more time to 1/32, just press Loop Out once more. To exit the loop roll, release Set Cue.

You can get some cool instant loop roll effects by holding set cue and then hitting Pitch Bend -, pitch bend +. or loop In. (Loop out is the exception - it jsut increments, so if you want an instant 1/16 or 1/32, hold set cue, hit loop in then loop out.)

Also note that since the loop roll/beatmasher is in the same fx bank as the fx controls, you can play around with the settings using the FX knobs and buttons as you would normally. A nice way to exit your loop roll is to turn the D/W down, as the default is 100%.

New mapping attached.

[bartboy]

You should also check out Stormeagles Numark TC mapping it hasn't been updated past Traktor Version 2.0.1 but it still very good. It's posted on the forums somewhere.

[fffiiissshhh]

Thanks, i actually used to use his mapping quite a lot before i made this! Definitely a solid one too.

I guess i could make a video of mine like he did - that might be a good call, it's hard to explain the mapping via text but its actually quite intuitive and bug free now.

[WALLOO]

my numark total control error help plz
http://www.youtube.com/watch?v=qE6gb...XJ8ZfwwyxzHQUs

[Kwotgus]

cheers for this (:

[FauxReal]

Could someone here repost the latest mapping? I decided to drag my Total Control out of the closet as a small beater controller I could take for minor gigs.