Traktor mapping tips, tricks and questions.

[DJAdeSands]

No, the unit will come with a manual or document with what the midi return details are for each LED that you want to affect. (what info traktor sends to the controller to influence the conduct of the LED's)


Sent from my SM-G900F using Tapatalk

[khan.cross]

I found a mapping file, works quite good and solve the problem with the LED. I modified it to my demands and it is now like a charm. I can mix with that very good, except controlling the remix decks for one shoot samples like siren etc. Any ideas how to solve this?

[DJAdeSands]

Sample stuff ain't something I'm too good with. It's something I maybe should get onto!

Sent from my SM-G900F using Tapatalk

[vanStriean]

Hello,

I'm looking for midimaps for Denon MCX800.
Who can help me?

[apprentice01]

hi ppl
im mapping out my numark for traktor in windows
im slowly getting there
but im stumped at my eq low mid high

i basically select eq high
select learn
turn the knob
but the result is when i turn the knob the eq on traktor goes ballistic not smooth

i have tried with the modifer option
syill no good
can you pleaze help

[Stewe]

hi ppl
im mapping out my numark for traktor in windows
im slowly getting there
but im stumped at my eq low mid high

i basically select eq high
select learn
turn the knob
but the result is when i turn the knob the eq on traktor goes ballistic not smooth

i have tried with the modifer option
syill no good
can you pleaze help

Which Numark is it? Is that an encoder or a simple rotary knob?

[apprentice01]

Which Numark is it? Is that an encoder or a simple rotary knob?

im not sure
the controller is a numark nv

[Stewe]

im not sure
the controller is a numark nv

I believe that NV rotaries are sending out two CC messages - ensure both messages are assigned to a command you're trying to control with those knobs. For example your assignment tab (right next to the 'Learn' button) should look like this: Ch1.CC001+Ch1.CC002

[padi_04]

Yeah, that's the trick. The knobs are sending a higher resolution message that way. RX has the same behaviour.

[apprentice01]

I believe that NV rotaries are sending out two CC messages - ensure both messages are assigned to a command you're trying to control with those knobs. For example your assignment tab (right next to the 'Learn' button) should look like this: Ch1.CC001+Ch1.CC002

thanks