
Originally Posted by
formantzero
I read this (and other related) threads hoping to find an answer to this frustrating issue — people posting that with the shift encoder hold set on a knob, a turn would send CC messages on channel 1. No matter what channel was selected for the knob, or for the encoder switch, after pressing the encoder and holding it down and twisting, it would always go to channel 1.
This behaviour was easy to see by configuring the knob to be on a different channel. Then you can clearly see: knob turn sends CC on the chosen channel, pressing the knob sends CC on ch2, and pressing/holding and turning sends CC on ch1. There seems to be no way to configure this in the utility.
Many people reported the same thing, and confusion because the manual says the shift encoder hold should, when held and turned, send on midi channel 5. And for some people it was working.
Someone mentioned you have to factory reset. People have said they tried that and it still didn’t work. I myself tried it and it didn’t work.
Here’s the mistake I made. You can’t factory reset and then just import settings you exported BEFORE the factory reset. Those settings seem to have ch 1 baked in. Since it isn’t selectable in the utility the way the default (non held) channel and the encoder switch channels are, or even the system midi channel, it just seemed to default to 1. With the newest firmware if you factory reset first, then this defaults to ch5 on shift encoder hold. This is what we are all expecting.
So the bottom line is get the latest firmware. Upgrade. Then reset to factory settings. Then remap all your knobs and colours from scratch. Do not import a settings file made before the reset. I did this and am now happily sending on ch5 with any of the knobs I’ve set to shift encoder hold.
Bookmarks