cant use my usb audio interface with traktor

[vladikpri]

hii
i use my pc with my on board realtech audio card device
and the usb one for headphones:
http://www.geardiary.com/wp-content/...ntroller_1.jpg

how i configure traktor to cue trough the usb card?
it gives me only the optin to choose between one of then but not both

thanks

[Foreverhex]

I have never used one of them before usb devices but maybe ASIO for all might help you.

http://www.asio4all.com/

[tekki]

Switch off is the only option.

But if I am correct, you are able to route the sound settings in such a way, that a second sound card should not be needed?

[vladikpri]

how i do this?
when i try to route only one card i always hear the cue through the master

[BentoSan]

how i do this?
when i try to route only one card i always hear the cue through the master

I really advise against using 2 soundscards, getting the latency settings right so both cards play the audio at exactly the same time can be rather difficult, especially if your new to all this stuff.

But if I am correct, you are able to route the sound settings in such a way, that a second sound card should not be needed?

His internal soundcard most likely only has 1x stereo out, and the usb device only has 1x stereo out. So currently he rather need the 2 sound cards, or needs to get himself a new soundcard.


Oh but answering the question, yes it is possible, you need to use asio4all for the drivers.