Crossfader doesn't work on page 2

[DvlsAdvct]

Hey guys

So, yeah, my crossfader broke too.

When I switch to MIDI page 2 in Traktor to control decks C and D I get no response from the crossfader. I move the VCI-100 fader and it does not move on screen, nor is there any response through audio.

It only happens on page 2, it works fine on page 1. Once again, the fader does not move on the screen at all once I switch to page 2.

I have set the crossfader in the tks the same. It learns it, but it will not move. This has been a frustration.

Any ideas?

[VoOFA]

hey dvlsadvct

i havent experienced this problem, but i have tried a lot of wierd things happening, and eveytime my backup of the Traktor3 folder has saved me...

my humble advice to y'all: keep a good backup!

i know this probably doesnt help you much now, but it will in the future

[Flaekiface]

I would try copying the setup from page 2 to page 3 or 4 to figure out if its a page related problem. Then I would try aplying deck C and D (after backning up) to page 1 to see if its a deck related problem.

When you have deck A and B playing and switch to page 2 with deck C and D, does moving the Xfader effect deck A and B?

Voofa - What do you back up? Just the 3 settings.xml files and the tks?

[DvlsAdvct]

I keep backups, that's not the problem, but thanks.

I haven't tried it on other pages yet, Flaek... will try that tomorrow

[VoOFA]

Voofa - What do you back up? Just the 3 settings.xml files and the tks?

i always backup the whole traktor 3 settings directory, on mac its placed in the user directory. then i draw files from that depending on what problems i encounter :]