AKAI APC 40 change LED-Ring config.

[kentwist]

I Just figured it out now Thanks so much for the pictures, that helped alot!

I thought the Device mapping was the same for controlling and sending out light.. I dunno what I was thinking

Nice little thing to know while mapping LED knobs for the Midi Out:

Top 8 knobs, top left to bottom right:
Ch01.CC056 - Ch01.CC63
Bottom 8 knobs, top left to bottom right:
Ch01.CC024 - Ch01.CC031

Thanks for helping me on this.

[kentwist]

Actually, I have one more issue that is still not resolved...

I am mapping all my knobs on the apc40 to a eq type of knob. The top 8 is mapped up correctly and is starting in the middle.

The 8 bottom of the knobs is always starting at point -10, of a scale of -10 being all the way left, 0 being middle, and 10 being all the way right. I really want the bottom knobs also to always start at position 0.

Anyone have tried this?

[David Schonborn]

I mapped my knobs this way, but when I turn them slowly the knob skips back making fine adjustments impossible. Does anyone know how I can fix this?

EDIT: Solved, I just screwed it up

kentwist: Are you using dumb mode on your apc40?

[kentwist]

I mapped my knobs this way, but when I turn them slowly the knob skips back making fine adjustments impossible. Does anyone know how I can fix this?

EDIT: Solved, I just screwed it up

kentwist: Are you using dumb mode on your apc40?

I Havent really figured out what dump mode is, but I think it's when you start ableton, then everything resetts. I'm guessing this si dumb mode, please correct me if I'm wrong

I'm doing that though, resetting through Ableton, but it sounds to me like you are mapping the same Midi out as the control. I had the same issue when doing that. The Midi out for the LED is different from what controls it. Did you check that?