Track control LED refresh issue

[fasorud]

Sure thing! I attached it.

The tsi also shows the issue i originally described, i.e. when a switch from pan to send the know doesn't go to the correct position, but rather starts from where it was before the switch back.

[padi_04]

You don't need the modifier outs to be affected by the modifier condition, that is your problem. What you need to change once you cleared that is the controller range as follows.

Pan: 0-0
Send A: 1-1
Send B: 2-2
Send C: 3-3

I'll see if i can fix your other issue in the morning, i need to replicate it in lemur since i sold my apc over a year ago.

[fasorud]

What you need to change once you cleared that is the controller range as follows.

Pan: 0-0
Send A: 1-1
Send B: 2-2
Send C: 3-3

I am assuming this will be in the modifier outs right?
So controller would be as you describe, and midi values 0-127?

[fasorud]

PADI that did the trick! the lights and buttons now cycle correctly. Any ideas on the knob position refresh?

[fasorud]

Anyone else able to help with this? I am still having a problem with not only the LED refresh, but also the position of the knob when switching.

To keep it simple:
Track Control knob 1 is high Eq for Deck A when Pan is checked, and Gain for Deck A when Send A is checked. If i have Pan checked and I turn the knob all the way to the right, and switch to Send A for Gain, it sets the gain all the way to the right too as soon as I touch the knob.

Any ideas?

[fasorud]

Anyone? BTW, I am doing all this in DUMB mode

[Glitchsbrew]

Anyone? BTW, I am doing all this in DUMB mode

I'm having the same problem.

[fasorud]

I'm having the same problem.

Still having this. I kinda gave up and limited the mapped functionality so I don't have to switch. Would like to get it fixed though!

[padi_04]

It's a hardware limitation since they are endless knobs, not encoders.

A workaround is mapping each midi out also to the same cc the knobs work on (and cc+8 for feedback) and a send monitor state to the control you use to switch layer. This does introduce another issue tho. Hardware and software will be fighting each other over the knob's position so the controls will feel slower than they normally do or even flicker if your latency is high enough.

You could try making the outs on the same cc work only when a modifier is active (ie: when the change layer control is pressed), assuming you have mods left for this.

For this reason alone is why i kept my mappings in regular mode and used the bank buttons to switch between 9 layers for the device control knobs.

[Glitchsbrew]

I just put everything on soft takeover. I don't really mind the LED feedback being incorrect and as long as they're not jumping all over the place I'm fine. I am however wondering something else.. I've been trying to recreate that default effect you get when you turn on the APC without a usb connection? The LEDs roll around all crazy one ring at a time. I really wish I knew how to make it do it on its own. Thoughts?