Quick Q....

[Patch]

Okay - odd thing. This doesn't seen to work with Flux Mode.

Anyone know why that is? Flux mode doesn't seem to engage unless the loop is stored as a hotcue???

[makar1]

Flux only works when you hold down a hotcue/loop, otherwise it won't know when to go back to the normal track.

[Patch]

So no way of using my little Loop Half Size macro with Flux, then?

[makar1]

Isn't that by definition the DJM Slip Roll effect?

[Stewe]

So no way of using my little Loop Half Size macro with Flux, then?

Do you use "Set Loop"? The flux mode would ignore "set+size" and "active on".

[Patch]

These are the commands I use:

Map the following actions to one key to achieve this effect:

1) Cue/Loop Move Mode : Loop Out
2) Cue/Loop Move Size : Loop (this doubles / halves the loop size)
3) Cue/Loop Move : Back

This way you halve the loop size by moving the end of the loop. You can do the same by moving the beginning (Mode : Loop In) forward (move : forward)

[makar1]

It still works as along as you set the full size loop and store it beforehand.

[Stewe]

These are the commands I use:

Ok - that's cool. But I'm talking about actual engaging loops in flux mode that you made a question for.

Map that set loop command in push encoder and you're all set. If you still want to set certain size you can map loop size selector to the same push button

type = button / interaction = direct