Introducing: The Bifrost (a freeware utility that beat-syncs midi devices to Traktor

[Stewe]

It differs from typical midi-clock sync because it allows you to build the Midi Twister's Remix Deck Sequencer into any controller...

How about the Twister's snap shot recorder feature? I know I can set and store them in to mapping but how do you save this settings after re-starting traktor?

[Phi]

You can use "virtual" nodes to operate as RAM/ROM to store each snapshot, but you are correct that the RAM would reset when you close Traktor.

We just need a .tsi editor to use this routing language and it would become quite a bit easier to create advanced utilities.

[astromech]

Does it work with external devices? I want to try and use RD4 on my Nexus 7, quantised to Traktor, but the best I can get currently is simple tempo sync.

[Patch]

Wait - nested modifiers? That's got me thinking.......

[Phi]

Does it work with external devices? I want to try and use RD4 on my Nexus 7, quantised to Traktor, but the best I can get currently is simple tempo sync.

Yes, it's a midi re-routing system built into Traktor's interface so it treats all midi devices the same way.

[Phi]

So I could possibly get my Numark Orbit to act like a Midifighter Twister step sequencer?

Yes, I have classes today and tomorrow, but I will try to finish the walkthrough this weekend.

Cheers!

[Stewe]

This technique looks promising. I've actually managed to set the sequence, yeeeeiiii

[Phi]

Thanks,

I'm using four 1-4 mod counts to clean up the trail on the 64th notes. It should look like Maschine's stepper with only one pad lighting up at a time. Plus it will make it easier for people to transfer to another controller if they just have to link mod value outputs to remix cells. I'll send you that one later.

[Stewe]

It's my bad camera which is causing a trail effect in a sequence - not fault of the mapping!

[Phi]

Did you slow the track down 90% and watch the leds? The file I sent you has a one led trail. I know you said you fixed a timing error, but unless you work with super low speeds there might still be an led crossover that needs to be edited out.. Thanks for the help btw.