UC-33 with Traktor

[BentoSan]

Yes everything works except the buttons on the right side.. If i try to "learn" them in Traktor they all want to do the same function.

I don't know what you mean by 1/16.. sorry.

That sounds like an issue with the UC sending the same midi message for all those knobs, run the device though a midi monitor like midiox and see if those notes are:
1) all indeed the same message
2) is it sending different velocities for these messages?

if it IS sending different velocties then its easy to turn use these different values to turn each into an individual midi message with Bomes midi translator(the free one)

Sorry to throw you in the deep end

[irrlichtlivepa]

i own an uc33e too. it 's impossible to do 16th on them.if u dont modify the tks u also have to double press them to switch state.
btw i combine an uc33e and an axiom25 to use traktor.

[colly]

Hello All,

I have just got a uc33. i am totally inexperienced with mappings.

Is there anyone who would be able to share their tsi file for the UC33 so I can get it working?

Thanks!

[wrong chris]

Yes everything works except the buttons on the right side.. If i try to "learn" them in Traktor they all want to do the same function.

I don't know what you mean by 1/16.. sorry.

read the manual and see the part about programming the knobs,faders,buttons. you can program what midi CC # each button/knob sends. Make sure each button/knob has a unique CC # or else you'll run into your problem.

[DSTRYD]

Hello All,

I have just got a uc33. i am totally inexperienced with mappings.

Is there anyone who would be able to share their tsi file for the UC33 so I can get it working?

Thanks!

I would also like one. Thanks

[padi_04]

I would also like one. Thanks

I just posted one on NI forum. there is some Enigma config needed but everything is explained on a readme file

http://www.native-instruments.com/fo...828#post603828