Any cool VCI 100 MK2 mapping?

[Stewe]

Ok then, we will use filter on button instead since KEY is starting to give me a headache. When you set modifiers 6 and 7 to toggle properly we shal continue...

[oriyong]

here we go

Screen Shot 2555-05-28 at 5.10.21 PM.png

[Stewe]

Next you need to do is to add in modifier 8 that will change FX presets for left jog wheel.

Add in modifier 8:
Modifier conditions: M4=1 ; M6=1
Type of control; Encoder
Interaction mode; Relative
Enc. mode: 3Fh/41h
Rotary sensitivity: 30%
Rotary acceleration 0%

Duplicate it and change settings to:
Modifier conditions: ....... ; M8=5
Type of control: Button
Interaction mode: Direct
Set to value: 1

Duplicate it again and change the following:
Modifier conditions: ....... ; M8=0
Type of control: Button
Interaction mode: Direct
Set to value: 4

[Stewe]

When you do it attach .tsi so I can edit /FX on/ LED outputs to be sure it's properly set.

[oriyong]

here you go

vci100mk2.tsi

when i apply the jog wheel into Learn function, do i have to touch the jog wheel and rotate it a bit right? coz i see different midi code between touch jogwheel and touch then rotate the jogwheel.

[Stewe]

here you go

vci100mk2.tsi

when i apply the jog wheel into Learn function, do i have to touch the jog wheel and rotate it a bit right? coz i see different midi code between touch jogwheel and touch then rotate the jogwheel.

Sorry I forgot to say that this M8 need to be assigned to NUDGE part of jog wheel.

[oriyong]

Next you need to do is to add in modifier 8 that will change FX presets for left jog wheel.

Add in modifier 8:
Modifier conditions: M4=1 ; M6=1
Type of control; Encoder
Interaction mode; Relative
Enc. mode: 3Fh/41h
Rotary sensitivity: 30%
Rotary acceleration 0%

Duplicate it and change settings to:
Modifier conditions: ....... ; M8=5
Type of control: Button
Interaction mode: Direct
Set to value: 1

Duplicate it again and change the following:
Modifier conditions: ....... ; M8=0
Type of control: Button
Interaction mode: Direct
Set to value: 4

Modifier conditons:.......; does it mean to leave blank or same no. above?

[oriyong]

Sorry I forgot to say that this M8 need to be assigned to NUDGE part of jog wheel.

Ok I did it with nudge part in the tsi i sent you

[Stewe]

Modifier conditons:.......; does it mean to leave blank or same no. above?

Yes leave it blank.

[oriyong]

Yes leave it blank.

Ok I did it right in the tsi that sent you.