Post Photos of Your MOD Gear HERE

[noblebrig]

So i just finished my VCI-100 mod.

I completely remapped the controller for basic mixing and the use of effects within Traktor. (Don't need the beat juggle functions because i will use another controller for that.)

[ToOntown]

By far one of the most creative cases for a controller.

These appear to be behind a pay wall

[djproben]

Wow... that's like the best post I've seen in years. Kudos! And where can I get some of those indestructible tubes with county comm microtowels? Talk about a party!

[derschaich]

33. housekey

brilliant!

[MrPopinjay]

16. Duct tape
24. Doan magnesium block
30. Morakniv Swedish Army knife
37. nylon knee-high pantyhose

WTF are you planning to do at the park?

[ToS]

SPAM is fun sometimes, eh?

[SpeshulEd]

Hey guys, when you see spam like this, just click the report post button and type spam...that should keep this thread clean. However, some of it is pretty funny.

[Karlos Santos]

Hey guys, when you see spam like this, just click the report post button and type spam...that should keep this thread clean. However, some of it is pretty funny.

+1 ... we have said it before. Report and ignore please.

[nobbycossie]

Thanks man, its my pride and joy! haha.

I DJ in a duo and we use both this and the s4. I've played around with a few different mappings but at the moment i'm using it for effects and samples.

The 4 rocker switches on the top left turn on all 4 effects units on decks A,B,C,D.

I was using the instant gratification mapping on the 4x4 grid originally however I have now mapped my own version. Starting from the top -
3 yellows are different beat slicer values, black is delay.
Oranges are reverb, purple is tape delay, white is reverse grain.
Greens are beatmasher.
Blues are gater, purple is LFO.

The horizontal fader is effects dry/wet.
Left vertical fader is a build (iceverb, peak filter, reverb) - tutorial on youtube.
Right vertical fader is volume fader for deck D (I keep white noise stored in one of the sample slots).
4 pots(in the vertical line) are all different super knobs i have come up with.
Two pots at the top right are for master tempo and browse - and the white button in the middle is a shift (so I can reset the pot to keep scrolling - have to do this because the umc32+ doesnt support encoders).
Top right white button cycles through deck D inputs (sample, track, live input).

Then on the front panel I have another rocker switch. With this on it puts the controller into sample mode where the grid loads / triggers samples, pots are filters and so on.

I hope that all makes sense! If anyone is planning on making a controller I highly recommend putting some rocker switches in. You can just map them as modifiers and then you can completely remap the controller for each switch - think of it as a shift key being permanently held down.

Mate thats awesome. Where is the YouTube vid for the build up you mentioned for left fader. Can someone post a link for me. Thanks in advance

[pauldesire35]

Oh man.. that is so sexy.. How long did all the sanding take? Jogs still have touch sensitivity?

Edit: Also, what's this additional controller you'll be using? Custom?
Sanding didn't took that long. I think i was done withing a hour for the controller. For the knobs it took a little bit longer but i did that when the controller was drying from the paint.