Gauging Interest in 4 Channel MIDI Mixer

[P4ULSON]

Soooo my mockup?

headphone jack on top at bottom left plz

[ProfessorStrangeman]

headphone jack on top at bottom left plz

On the front panel or the top panel?

EDIT: BRB. Learning Lessons.

[ProfessorStrangeman]

P4ULSON's Edit.

[synthet1c]

why not make a cavity that can fit an [audio => 8/10, serato => sl3, sl4] instead of including a soundcard, then you could just run patch cables throughout the inside of the box from the unmodified soundcard to the back of the box so you can wire everything up normally, it would be a bit messy to set up but once it's in the box you could forget about it.

[b1sh0p]

why not make a cavity that can fit an [audio => 8/10, serato => sl3, sl4] instead of including a soundcard, then you could just run patch cables throughout the inside of the box from the unmodified soundcard to the back of the box so you can wire everything up normally, it would be a bit messy to set up but once it's in the box you could forget about it.

That's basically the MM1. The MM1 has transport controls too and costs $130.

[synthet1c]

what your talking about is completely unrelated to my post bishop. An MM1 would never be able to fit an unmodified soundcard in it's original case. And transport controls are simply a couple of button's added to the design, but from what mdc was saying it would have pads or buttons to replicate the Z2 functionality.

[makar1]

The idea for this MIDI mixer was to have it the same height as modular controllers, so it wouldn't be able to fit a sound card either.