Thanks for your support guys!
I'm happy it was possible to adapt the DJTT mapping to support this new firmware, but for those using their own mapping, here's a list of all the changes changes since firmware 1.3.
Time for me to reassemble the unit and start mixing!
VCI-100 unofficial firmware 1.4 by DaveX
==========================================
After long hours of reverse-engineering, here's an improved firmware for your VCI!
New features
============
- 4x pitch faders resolutions
- 4x jog wheel resolution
- All the buttons under the jog wheels can now be lit using MIDI out messages
- Left sync button is now mapped to note G-8 (73 hex) and behaves like right one (no more hardware toggle) (LED is still mapped to note A#4, 46 hex)
- Filter knobs send both regular 0-127 CC message only (unlike 1.3 firmware)
- A MIDI CC command is sent along with the Note ON command when the pitch fader is centered (so it's possible to reach the exactly the center position even using the DJTT mappings)
- Outer part of jog wheels sends Midi ON/OFF message on separate channel when in scratch mode (channel 2)
Usage
=====
You must change the following to your Traktor mappings:
1) Remap your pitch faders:
- Deck A/C Tempo = CH02.PitchBend
- Deck B/D Tempo = CH03.PitchBend
- Deck A/C Tempo Reset = CH02.Note.C0
- Deck B/D Tempo Reset = CH02.Note.C#0
1) Remap your inner jog wheel messages in normal mode and in scratch mode
The messages are the same (CC16, CC17, CC18 and CC19) but on channel 2
instead of channel 1
2) Divide the jog wheel sensibility by 4
3) Remap the left sync button
Bonus #1
========
Did you know that there's a factory test mode hidden in every VCI ? It's used in the factory to test all the buttons, faders, knobs and LEDs.
With 1.4 firmware: While your VCI is off, hold RIGHT ECHO+PLAY buttons (VCI-100SE mapping) and turn it on.
With previous firmwares: While your VCI is off, hold LEFT ECHO+PLAY buttons (VCI-100SE mapping) and turn it on.
Bonus #2
========
Nobody on the dancefloor ? Boot your VCI in easter egg mode and beat the hidden game to enter the "Disco Mode" and see the crowd jumpin' in the air!!
That works only with 1.4 firmware of course, VCI will get detected by computer once Disco Mode is activated so you may use it "as usual". Hint: same trigger as factory test mode but with different buttons
Bookmarks