Show Your Setup Part II

[MrPopinjay]

/r/DJs

[suit]

I was inspired by the DJ furniture post and wanted to get my vinal out of the cupboard for a spin so i thought id give it a try.
The draws i had for a while, the top is laminated chip board and the rest is MDF, pine and a few heavy brackets from the hardware store.

[Era 7]

Reloop RMX-40 (wish i could replace it lol)
2x CDJ-800MK1
2x M-Audio BX8a Deluxe
pair of HDJ-2000s (it's an older picture hence my old Stanton headphones are still there)

[Steve_London]

Do your CDJ's not jump with the speakers so close to them and placed on the same table ?

[MrPopinjay]

CDJs can jump?

Era 7, what don' you like about the mixer? Or do you just want an upgrade?

[Steve_London]

Yes CDJ's can jump (hard to do but yes they can)

[Era 7]

Do your CDJ's not jump with the speakers so close to them and placed on the same table ?

they are built to work in a club environment you can rattle on them and even lift them up and tilt them while playing, they won't jump (i know, i tried lol). so they can handle the bass

CDJs can jump?

Era 7, what don' you like about the mixer? Or do you just want an upgrade?

just wanna upgrade. the mixer on it's own is fine but i'd like to get something more a little bit quality ya know but that's more of a money and priority problem.

[Steve_London]

As i own quite a few CDJ1000mk3's i can tell you that they can jump if the bass is strong or your using high powered DJ monitors on the same peace of Litedeck as the CDJ's are sitting on.

[Era 7]

As i own quite a few CDJ1000mk3's i can tell you that they can jump if the bass is strong or your using high powered DJ monitors on the same peace of Litedeck as the CDJ's are sitting on.

oh well haven't experienced any skipping until now. but i'm also using isolators. whit those sitting beneath the monitors you get no vibrations whatsoever on the surface the players are sitting on.

[Dustin V]

I was inspired by the DJ furniture post and wanted to get my vinal out of the cupboard for a spin so i thought id give it a try.
The draws i had for a while, the top is laminated chip board and the rest is MDF, pine and a few heavy brackets from the hardware store.

I like the disco ball bro!

Also digging the Camelot wheel chart you have up on the wall, I need to do the same, since I'm getting more deep into Harmonic mixing.