A part of the outer casing has slipped out from the Traktor logo part on one of my multicore cables and I was just looking to see if anyone that has had this problem has found a way to fix it. I can't see an easy way to open the logo bit so I can slide the wire back inside then close it again.

Lucky enough when I registered my new Audio 10 NI gave me a voucher for their online store so I've used that to buy a new replacement but I have a feeling it will be the version with the XLR connection in the middle of the wire so I'll have to buy another one to make them match.

This is the type of cable that I need some help with...
http://www.dougegen.de/wp-content/up...core_kabel.jpg

It's the middle part between the two big plastic Traktor logos. one end has slipped out.