I've got a target light out on my deck so i ordered a replacement LED kit from pimpmydecks. I'm handy with a soldering iron but know nothing about electronic so have been going over viperfranks's videos.
The instructions i've received are quite simple.. i've got the LED already attached to the cable ready to snip the capacitor and slot this in... but VF goes into more detail by adding a voltage regulator.
Im naturally inclined to follow VF's videos because he does an amazing job at explaining it, but want to know more about the differences? obviously if i can get the job done quicker and easier i'd like to go ahead with the easier method, i also read in the comments on youtube that the voltage regulator isn't needed..
This video ( ) talks through the 'easier' way. I have the same led/wire
thoughts?
Bookmarks