need help bad

[Zander]

so i have an apc 40 and i wanted to be able to cue my tracks out of it so i went ahead and bout 'komplete audio 6'

i figured it out to where i can cue my tracks, but the sound only comes out of one speaker, and one of my head phones. i dont understand. please help

[makar1]

What software are you using? And what hardware do you have, and how is it connected up?

[Sambo]

Open traktor's preferences, in Audio, make sure the Komplete 6 is chosen as your sound card, then go to routing, and put output 1 as your master and output 2 as your monitor, the L and R in each respectively.

I'm not sure how everything is supposed to look because I've never set up a Komplete Audio 6, which is different than a Traktor Audio 6.

[makar1]

Speakers should be connected to outputs 1 and 2 of the KA6, and Master output of your software should be routed there too.

Headphones should be connected to the front Phones port (select 3/4 using the switch) and the Monitor output should be routed to outputs 3 and 4 of the KA6.

[Zander]

I'm using ableton live 9

I have the audio 6 in through USB.
Apc50 in with USB

2 speakers and sennhizer headphones.

The headphones are in the headphone jack in the front, the monitors are in the 3/4 out pot in the back. But only one speaker on both the headphones and the speaker produces sount

[Zander]

Apc40*

[Zander]

Speakers should be connected to outputs 1 and 2 of the KA6, and Master output of your software should be routed there too.

Headphones should be connected to the front Phones port (select 3/4 using the switch) and the Monitor output should be routed to outputs 3 and 4 of the KA6.

I only have one jack for the speakers though

[avery]

Okay, so.. on the back of the KA 6, you've got one speaker plugged into output 3 and one speaker plugged into output 4, right? Those aren't stereo outputs..



Here's how I have the audio setup in Ableton:

ableton1.JPGableton2.JPG

[Zander]

Yeah but I only have one cable for both the speakers. Maybe I need to go out and buy additional cables? The other thing is when I connect it to the 'main' out let I don't get and sound out of either speaker, and I can't figure out how to configure my controlled panel to send the sound out of main.

[makar1]

Yes, you need 1 cable per speaker. There is a large dial in the middle of the device for controlling volume through the MAIN out.

What speakers are you using?