HID Support for the VCI 400 please!!!

[sugardaddy]

Hello,

is there any way the VCI 400 gets HID Support for Traktor Pro, so real scratching is possible???
Could you guys get in contact with Vestax and ask about this? Have you already done?

I am really happy with the DJTT VCI 400, but the fact that I can't do a propper cut is too bad...

Greetings from Switzerland

[donutsdc]

I may be wrong, but it has been discussed before that HID technology is licensed out by NI itself. The VCI-400 was never Traktor certified, henceforth no HID support. Vestax has been pretty quiet on this issue and many people have asked for it before. All we can do is wait to see if either NI will certify the VCI-400 or DJTT releases a new firmware that improves jogwheel response.