There's a few questions I have regarding traktor so instead of starting a thread for each one I thought I'd put them all in one.
I've already started a thread asking if 3 decks can be launched by pushing 3 separate buttons at the same time on a USB QWERTY keyboard so if anyone knows the answer to that then great.
Next question; If I manually set up a loop on the fly using the "in" and "out" buttons, is there a way of keeping that loop there without permanently storing it? I ask because when you hit a stored cue button the loop disappears. I don't want it to disappear until that track is no longer in the deck (kinda like a CDJ 1000).
Next question; This doesn't happen all the time and I'm sure there's a reason behind it but I can't seem to suss out any consistency as to when it does it, and it's something I need to know as to when it will do it as I don't want it happening when I play live... or at all for that matter!... Sometimes in internal mode if I repeatedly press play/pause or a hot cue button, so getting a stutter type effect, the pitch jumps up and down every time the button is pushed and eventually will end up right at the bottom of the pitch fader so the track is really slow. If I have 2 or more decks sync'd they'll all do it together. If this is some kind of feature then I can't see the benefit but anyway, if someone knows whats going on there then that would be helpful.
Next question: Is there a way of having all decks sync'd when booting up Traktor as opposed to doing manually (not a big deal but it would be nice if there was a way). I'd especially like decks C & D to always be sync'd unless I tell it otherwise.
Next question: This one is going to be hard to explain so not expecting anyone to know the answer unless they maybe set it up the same way to see what I am talking about. I have my loop "in" button mapped to automatically set a 4 bar loop when pressed. If I want it to be longer I use the "+" or "-" buttons to double it in length or halve it in length, I also can use the "out" button to adjust the loop end length manually. Now, my question is this; say I load a track and it loads to cue point 1, I hit the "in" button to make 4 a bar loop, if I hit play at the wrong place and need to do it again I'll hit cue point 1, meaning I have to reset the loop (which is what I covered in question 1), so I hit the loop "in" button again, but it will only do the 4 bar loop if I hit the "in" button twice. BUT, if I do this process again I only have to hit the "in" button once. So basically I have to hit the "in" button twice on every second time around. What I am going to say is obvious, I want to hit the button only once every time. Anyone?
Sorry for long post but at least I saved writing multiple threads. I'm sure more questions will come up and I'll be sure to add them to this post when they arise.
Thanks
Bookmarks