VCI-100 SE 3_1 mapping (updated)

[EanGolden]

a newer version of this mapping is now available in this thread:

http://www.djtechtools.com/forum/showthread.php?t=11330

[Sasha Solo]

nice first one here!!! I hope this tsi loads for me!!


Thanx Ean

SS

[Sasha Solo]

OK so big fix I think that needs to be made :

Have the Slice + Jogwheel reset each time!

I know that in the beta thats how it was, why not now?

SS

[MehdiVancouver]

Thank you so much Ean!!

[dros]

I noticed the Low/High Cut Filter Knobs stop working when FX Mode is "on". Is this because we don't have any FX module available in order to filter while FX mode is enabled or is it a bug?

Bug or not, I'd suggest the following mapping while FX mode is "on":
- moving the FX parameter assigned to the volume faders to these knobs in order to allow volume control while on FX mode
OR
- moving the FX parameter assigned to the pitch fader to these knobs in order to be able to add transposing to our FX performance.

[cuttymello]

It´s working for me now! Had two versions of Traktor installed and kept opening the old 1.2.2 version so it didn´t import the tsi. very very

New version new tsi everything fine now i only have to start playing with it.

things learned
the 3.0 setup defenitely only runs with Traktor 1.2.4.
you can have 2 working versions of Traktor on a mac wich can come handy with future updates
i should remember where i put things before trying to upgrade

[cuttymello]

Found out that somehow the XFade had the same controler set as the DRY/Wet knob on Fx1
Deleting the Control for dry/wet fixed the prblm

[MisterMoleyMole]

OK so big fix I think that needs to be made :

Have the Slice + Jogwheel reset each time!

I know that in the beta thats how it was, why not now?

SS

I'm with you here, it was mentioned in the last thread. Its been rdone like this deliberatley though. Can't be to difficult to change yourself i dont think.

[cuttymello]

I think i found a next thing there´s that problem that on Deck A/D u have to press sync twice to sync as described earlier by smbdy in the old 3.0 thread.

I suppouse this is because the Sync Out on Deck A (Ch2 Note A#4) misses is´t second modifier i added M4=0 as second Mod and it seems to work now.

Hope this is a solution and doesn´t bring up other prblms will keep on checking

[deejaybeam]

I think there is something went wrong with zipping...

The solution:

1. download the file from Ean
2. extract the File in the zip (it has no extension!)
3. now you can open the extracted file with winrar (or add extension .zip)

now you should have 2 directoris one for mac an one for win...

everythin should work now!

but only if you use traktor 1.2.4 - if you have an oder Version you could not import controller settings!