ok, so i get that there's the four banks (?) of effects in Pro, can they be assigned to any deck, or is it 1-1 2-2 3-3 4-4?
also can the assignment be switched with a hotkey/midi cc? or based on focus?
for example i have 4 buttons on my nanopad, one to set the focus to either a, b, c or d. will the selected fx bank act on that selected deck?
also how do you tell it which bank to use? or is that based on the assignment?
for example, atm i have a slightly different xy layout on each of the pages of the nano, one for the bp filter, one for l/h filter, one for flange and one for beatmasher. when i hold it, it turns the effect on and sets the amt to full with the other 2 xy signals controlling specific knobs and stops when i release, is there then an additional control i set to identify which effect bank it is doing this on?
so
1) tells it bank
2) tells it on ------------>these for example are c16, with 0 and 1 on x and y
3) sets the amt
and the would the commands in the map be;
1) select effect bank [1-4] [deck-focus] <c16>
2) effect button 1 [on/hold] [deck-focus] <c16>
3) effect knob 1 [button, resolution 254] [deck-focus] <c16>
(i think it's resolution, the one that tells it how far to turn the knob with the button push, as not using a fader/knob)
2+3 are what i'm using in T3 at the moment with the required knobs set on x & y with inverts set if more than one on an axis and i want them opposing each other for balance
cheers guys
Bookmarks