2 Things

[blancodisco]

1) Perhaps I've missed this being discussed already, but why the does the 1.3 Firmware always default load to FX Bank B? and not A? Not that big of a deal.. but just wondering if there was some reasoning behind that.

2) Sometimes, while doing a mix session.. the right platter jog wheel (Deck B) will just STOP being able to sense or send out the Pitch down / Nudge controller data. Nudging up works fine, but Down will just stop. I've figured out that I can turn off the unit and power back on and it works again.

Is this a hardware issue or software?

I'm using the VCI-100SE_1_3_TT_Style.tks file, btw.

[Jah Roc]

when i understand u right, u got the same problem like me, just with the right jogwheel....
http://www.djtechtools.com/forum/showthread.php?t=1101

i fixed the jogwheel so often that it´s now totally broken...so is it a firmware error??

[BentoSan]

Do you guys know the steps to replicating this issue ?

Also have you used midi monitoring program like midi-ox to see if the vci is sending out different midi messages that are not linked to anything in Traktor when this is happening ?

[Jah Roc]

i have only checked the midi page in traktor... i do not use midi ox that often...let´s see what i can do

[Jah Roc]

so bento, this is what midi ox shows me while pitchbending




can u tell me what i have to do next?! i´m sorry i´ve got no ideas

[lassemy]

@blancodisco

I also had the same problem with the right jogwheel when i activated a loop.
I looked at midi page #1 and found that deck A sends 2 notes on Deck Tempo Bend Down. So i added a Deck Tempo Bend Down for Deck B with the Note E#8, resolution fine. And that fixed it for me. Hope this helps.

[BentoSan]

so bento, this is what midi ox shows me while pitchbending




can u tell me what i have to do next?! i´m sorry i´ve got no ideas

Was that taken when the jog wheel wasnt working in traktor ?

[Jah Roc]

yes only midi ox was activated...

but i have got another idea. when updating the firmware, you have to remove one cable...and i remember that it was a cable to the jogwheels...or not? this cable could be broken... i will check that cable later this day and also update again...

[Jah Roc]

ok, i did the update again but no changes..f***

[blancodisco]

@blancodisco

I also had the same problem with the right jogwheel when i activated a loop.
I looked at midi page #1 and found that deck A sends 2 notes on Deck Tempo Bend Down. So i added a Deck Tempo Bend Down for Deck B with the Note E#8, resolution fine. And that fixed it for me. Hope this helps.

I'll give this a try this evening and see if it's just a mishap on the config.
If so... perhaps Ean should just double check his work and repost for others.

If this doesn't work, i'll then respond to the steps (which may or not be exactly repeatable) to make this situation occur.

Thanks for the responses thus far though.