I recently purchased the LPD8 which I am pretty content with overall. I downloaded the a tsi from this website and got everything imported which is all cool. However I noticed that sometimes the pads and knobs just didn't do what they were mapped to. I figured it had to do with the original mappings so I decided to trash those and make my own.
Everything was going fine until I wanted to add loops (loop in/loop out/loop active) to a program. Let's say I would map "loop in" to be CH3CC6, "loop out" to be CH3CC7, and "loop active" to be CH3CC8, all for deck A. I tested it while loop in was working, loop out didn't register on any pad or knob at all and loop active took loop out's mapping. I fiddled around with it for quite a while, completely removing everything, reverting to the standard tsi and going back again...and so on. Still the same issue.
It all looks mapped a-ok...but why won't it register? This is my first midi-controller so I really don't know if this is a normal thing (I really hope it isn't) that sometimes buttons just don't register.
Any clues here?
edit:
I should probably add that I am using Traktor Pro and Windows.
Bookmarks